This retrofit solution enables Civic 1.5T owners to utilize the superior holding power of a Type R clutch, providing a significant increase in torque capacity over the stock unit

Clutch that can be used with :

Exedy - Stage 0 OE Clutch Kit - K20C1

Exedy - Stage 1 OE Clutch Kit - K20C1

RV6 Type R Retrofit Flywheel Kit for 2016+ Honda Civic 1.5T Base & Si / 2023+ Acura Integra 1.5T

Looking for a factory feeling clutch that can hold real power? Check out the RV6 1.5T FK8 Clutch Retro Flywheel. This flywheel allows you to run a 17+ Civic Type R (FK8) clutch disc and pressure plate in your 1.5T Si or any 1.5T manual equipped car.

With factory FK8 clutches holding over 400FT/LB of torque and available at any dealer. This is a great option for those that want upgrade without a leg workout. This flywheel also allows you to run the plethora of upgraded aftermarket FK8 clutches and pressure plates for those looking to push the limits.

Is it lightweight? RV6 1.5T FK8 Clutch Retro Flywheel 42% lighter than stock. (Actual weight 20.5lbs) We could have gone lighter however the issue with running a flywheel that is too light is that your will trip the misfire detection within ECU and throw an error code never allowing you to pass inspection. Light weight flywheels are also easier to stall and harder to launch. They also make the engine run rough at lower RPMs due to the lack of inertia. The main goal of this setup is to hold power without sacrificing comfort or drivability.

Features

• Made from high strength forged chromoly
• Run any factory or aftermarket FK8 clutch and pressure plate
• Retains pilot bushing for input shaft
• 42% lighter than factory flywheel
• Fully machined and balanced
• Holds more power without sacrificing comfort or drivability

Applications

• 2023+ Acura Integra A-Spec - Manual Transmission
• 2023+ Acura Integra Base - Manual Transmission
• 2017-2021 Honda Civic Hatchback - Manual Transmission
• 2016-2025 Honda Civic Si - Manual Transmission
• 2016-2025 Honda Civic Touring - Manual Transmission

What's In The Box?

• 1 - Retro Flywheel
• 1 - Pilot Bushing (Pre-Installed)
• 1 - Pivot Bolt Spacer (DO NOT FORGET TO INSTALL)
• 8 - M12 x 1.0 x 32.5mm OHL Flywheel Bolts

References

• Installation Instructions