Want to ditch the stock knob but you cannot stand the sad, saggy boot look? Same. The Hybrid Racing shift boot collar fixes that in a clean, two piece setup that replaces the factory collar and plays nice with a stock knob or pretty much any aftermarket shift knob you want to run. If you want a universal shift boot collar vibe without hacky zip ties, this is it.

The stainless steel shift collar center section threads onto any M10x1.5 rod, then it clips into the titanium shift boot collar. That gives you a shift boot collar with sleeve that actually holds the boot where it should sit, even after a few hot days in the car. Install stays simple, this is an easy install shift boot collar job, and you only need a 17mm wrench to snug the sleeve against any flat bottom knob. This hybrid racing shift boot collar also works great as an elastic band shift collar alternative, since you get a secure mechanical hold instead of a band that can slip.

This Maxim shift boot collar uses a machined titanium shift collar outer piece, so you get that dust titanium boot collar look, or that titanium blue shift collar look depending on the batch, without pretending every part matches perfectly. Real talk, titanium finishes vary.